Hello Nitin and Lakeer,
I think Nitin has answered your Question. Got the results as Nitin has written in his last post. If sampling procedure is not used system shows 1 in "Inspect". (Don't know the exact reason ).
Come up with your observations too.
I have not used any sampling procedure . Also i don't want to use it
But as you do not want Sampling procedure, and in case using sampling procedure is the only solution, I would suggest you to Maintain Sampling procedure in "plant dependent QM settings".
This sampling procedure does not apply, however, in the case of inspections with inspection points.
Or
Apply sampling procedure to an Inspection type
Amol.